S-7200C
4.
FUNCTION SETTINGS (G50 OPERATION PANEL)
9
Presser foot lifter operation and pedal operation settings (001-) No. Setting
range
Initial
value
Setting
units Setting details
001 ON/OFF OFF -
Presser foot status when treadle is returned to neutral after thread trimming
ON: Presser foot does not drop
OFF: Presser foot drops (Presser foot will not drop if No. 851 is set to OFF.)
002 ON/OFF OFF -
Presser foot status after treadle stops at neutral
ON: Presser foot lifts
OFF: Presser foot does not lift
003 ON/OFF ON -
Presser foot lifting when treadle is depressed backward to 1st step after
returning to neutral
* If No. 004 is “OFF”, this function will operate as if the setting is “OFF”.
ON: Possible
OFF: Not possible
004 ON/OFF ON -
Operation when treadle is depressed backward
ON: Thread trimming and end backtack sewing operations are enabled
(If thread trimming operation has been disabled, needle up operations
will be carried out without thread trimming.)
OFF: Thread trimming and end backtack sewing operations are disabled
(Presser foot is raised when treadle is depressed backward.)
010 ON/OFF OFF -
Alternate standing operation pedal and treadle operation
ON: Standing operation pedal and the treadle can operate alternately
(If the standing operation pedal and the treadle are operated at the same
time, the standing operation pedal will have priority.)
OFF: Treadle operation can also be used after standing operation pedal is used
011 0-2 0 1
Operation when standing operation variable speed pedal is on
0: Sewing speed corresponds to treadle depression amount
1: Sewing speed corresponds to sewing speed control key setting
(constant speed)
2: Sewing speed corresponds to end backtack speed
012 0-500
(ms)
80
(ms)
10
(ms) Delay time from standing pedal turning on until motor starts operating
013 ON/OFF ON -
Pause function during standing operation when presser foot lifter pedal is
operated (when AUTO key is set to ON)
ON: Operation pauses during sewing when presser foot lifter pedal is ON
OFF: No operation
014 ON/OFF ON -
Pause function during standing operation when high-speed pedal is operated
(when AUTO key is set to ON)
ON: Operation pauses during sewing when high-speed pedal turns ON once
more. Sewing is resumed when high-speed pedal next turns OFF.
OFF: No operation
015 ON/OFF ON -
Presser foot lifting operation from thread trimming pedal after thread is
trimmed during standing operation
ON: Presser foot can be lifted and lowered
(If No. 051 is “OFF”, the thread trimming pedal operation is disabled after
the presser foot lifter pedal has been operated during standing
operation.)
OFF: No operation (Only possible by using presser foot lifter pedal.)