![](/images/new-backgrounds/1060033/6003333x1.webp)
Stitch Length
To change the stitch length,
(1)Locate the stitch length adjustment dial on the left side of the machine.
(2)Turn the stitch length adjustment dial forward to lengthen the stitch to a maximum of 4 mm (5/32 inch).
Turn the stitch length adjustment dial backwards to shorten the stitch length to a minimum of 2 mm (1/8 inch).
(3)The normal stitch length setting is 2.5 mm to 3 mm.
2 3
R
Largo de puntada
Para cambiar el largo de las puntada:
(1)Busque el disco de ajuste del largo de las punta- das en al lado izquierdo de la máquina.
(2)Gire el disco de ajuste del largo de las puntadas hacia adelante para alargar la puntada a un máximo de 4 mm.
Gire el disco de ajuste del largo de las puntadas hacia atrás para acortar la longitud de puntada a un mínimo de 2 mm.
*Un ajuste normal para el largo de las puntadas se sitúa entre 2,5 y 3 mm.
4
TABLE OF CONTENTS |
Chapter 1 |
Chapter 2 |
Chapter 3 |
Chapter 4 |
Chapter 5 |
Chapter 6 |
Chapter 7 |
Stitch Width
Two-needle models
To change the stitch width.
(1)Move the stitch width lever (located on the left side of the machine toward the front) up to reduce the stitch width or down to increase the width.
The stitch width can be set between R4.5 mm (11/ 64 inch) and 7 mm (9/32 inch).
The normal stitch width setting for regular overlock stitch is 5mm (13/64 inch).
One-needle models
∙The width is factory set to 3.5mm (9/64 inch). A
B
1Stitch width lever
2Regular needle plate
A 6 7
5 | 2 |
| |
R |
|
1
Ancho de puntada
Modelos de dos agujas.
∙Para cambiar el ancho de puntada.
(1)Mueva la palanca de anchura de las puntadas (situada a la izquierda de la máquina, hacia adelante) hacia arriba para reducir el ancho de puntada, o hacia abajo para aumentar el ancho de puntada.
Puede ajustar el ancho de puntada entre R4,5
mm y 7 mm.
El ajuste normal del ancho de puntada para una puntada overlock corriente es de 5 mm.
Modelos de una aguja.
∙El ancho de las puntadas está establecido en la fábrica en 3,5 mm.
AModelos de dos agujas B Modelos de una aguja
1Palanca de anchura de las puntadas
2Place de aguja normal
B
2
3.5
R
1
10
Chapter 8 | |
Chapter 9 | |
10 | Chapter |
11 | Chapter |
12 | Chapter |
13 | Chapter |
14 | Chapter |
15 | Chapter |
16 | Chapter |
17 | Chapter |
18 | Chapter |