Bryant instruction manual Unit583B, Safety Considerations, 583B Sizes, Phasesingle Package

installation, start-up,

and operating instructions

3-PHASE SINGLE PACKAGE

GAS HEATING/AIR CONDITIONERS WITH PURON® (R-410A) REFRIGERANT

583B Sizes 030-060

Cancels: New	II 583B-30-1
	2-06

Low NOx Models Available
NOTE: Read the entire instruction manual before starting the
installation.
Index	Page
SAFETY CONSIDERATIONS	1
RULES FOR SAFE INSTALLATION AND OPERATION	....1-2
RECEIVING AND INSTALLATION	2
CHECK EQUIPMENT	2
PROVIDE UNIT SUPPORT	2
Roof Curb	2
Slab Mount	2
Ground Mount	2
FIELD FABRICATE DUCTWORK	2-3
PROVIDE CLEARANCES	4-7
RIG AND PLACE UNIT	7-8
CONNECT CONDENSATE DRAIN	8
INSTALL FLUE HOOD	8
INSTALL GAS PIPING	9
INSTALL DUCT CONNECTIONS	10-11
INSTALL ELECTRICAL CONNECTIONS	12-14
High-Voltage Connections	12
Special Procedures for 208-V Operation	12
Control Voltage Connections	13
Standard Connection	13
Heat Anticipator Setting	13-14

Fig. 1—Unit 583B

C99087

Transformer Protection	14
PRE-START-UP	14
START-UP	14-23
MAINTENANCE	23-27
REFRIGERANT SYSTEM	27
QUICK REFERENCE GUIDE	28
TROUBLESHOOTING	29-31
START-UP CHECKLIST	32
NOTE TO INSTALLER — Before the installation, READ
THESE INSTRUCTIONS CAREFULLY AND COMPLETELY.
Also, make sure the User’s Manual and Replacement Guide are
left with the unit after installation. the furnace is NOT to be used
for temporary heating of buildings or structures under construc-
tion.
SAFETY CONSIDERATIONS
Installation and servicing of air-conditioning equipment can be
hazardous due to system pressure and electrical components. Only
trained and qualified personnel should install, repair, or service
air-conditioning equipment.
Untrained personnel can perform basic maintenance functions of
cleaning coils and filters. All other operations should be performed
by trained service personnel. When working on air-conditioning
equipment, observe precautions in the literature, tags and labels
attached to the unit, and other safety precautions that may apply.
Follow all safety codes. Wear safety glasses and work gloves. Use
quenching cloth for unbrazing operations. Have fire extinguisher
available for all brazing operations.

—1—

RULES FOR SAFE INSTALLATION AND OPERATION

WARNING: Improper installation, adjustment, alter- ation, service, maintenance, or use can cause carbon monoxide poisoning, fire, or an explosion which can result in serious injury or unit damage. Consult a quali- fied installer, service agency, or gas supplier for infor- mation or assistance. The qualified installer or agency must use only factory-authorized kits or accessories when modifying this product.

Understand the signal words —DANGER, WARNING, and CAUTION. DANGER identifies the most serious hazards which will result in severe serious injury or death. WARNING indicates a condition that could result in serious injury or death. CAUTION is used to identify unsafe practices which would result in minor or moderate injury or product and property damage.

The power supply (volts, phase, and hertz) must correspond to that specified on unit rating plate.

The electrical supply provided by the utility must be sufficient to handle load imposed by this unit.

This installation must conform with local building codes and with NEC (National Electrical Code) and NFPA 70, NFPA 54/ANSI Z223.1 latest revision, and NFGC (National Fuel Gas Code). Refer to provincial and local plumbing or waste water codes and other applicable local codes.

Approved for outdoor installation on wood flooring or on class A, B or C roof covering materials.