Setting up
Please note that your handset is already registered to the base station.
Plan the location
Situate your product close enough to the telephone and mains power sockets so that the cables will reach. The only way to disconnect the product from the power supply is to remove the power adaptor from the mains power socket. Therefore you must ensure you plan the location so that the mains power is easily accessed.
Make sure it is at least 1 metre away from other electrical products to avoid interference.
Do not situate the product in the bathroom or other humid areas.
1Connect the power supply and switch on
Important
You must thread the power supply cable and line cord through the plinth before you connect to the power supply.
Plinth
Plug the power supply cable into the socket on the underside of your base. The power cable connector and socket are coloured red.
Plug the line cord into the other socket on the underside of the base marked with a telephone symbol.
WARNING
Please take care that the power supply and telephone line cord are connected to the correct sockets as incorrect placement could damage your equipment.
Once connected, put the plinth back on the base to prevent it from rocking on the table.
There are two positions for the plinth when joining it to the base, both can be used for desk mounting and one for wall mounting. Position
Ais for desk mounting only and position B is for desk or wall mounting (see Wall mounting on page 29).
AB
Rubber feet
Hold the black plastic square between thumb and forefinger and peel off individual feet from backing sheet as shown. These are to stop your base from moving and to protect your work surface.
5
