SETTING UP
Synergy 600 user guide ~ 6th Edition ~ 20th June ’01 ~ 3718
8
A battery pack is pre-installed within
the handset.
Place the handset on the base station.
The red charging light will come on.
The battery symbol is shown on the
display during charging. Leave to
charge for at least 16 hours.
Once the handset is fully charged, the
display shows a full battery symbol.
BATTERY LEVELS
WEAK HALF-FULL FULL
2Charge the handset battery
pack for at least 16 hours
Battery low warning
If the handset battery symbol is empty
and flashing, and you hear a warning
beep every 10 seconds, you will need
to recharge your handset before you
can use it.
Helpline
If you are experiencing difficulty,
please call the Synergy Helpline on
0845 769 7146.
Battery performance
The charge capacity of rechargeable
battery packs will reduce with time as
they wear out, so reducing
talk/standby time of the handset.
Eventually they will need to be
replaced. New battery packs can be
obtained from any BT Shop or from
the Helpline on 0845 769 7146.
After charging your handset for the
first time, subsequent charging time
for the battery pack is approximately
6-8 hours a day. Battery pack and
case may become warm during
charging, this is normal.
Under ideal conditions, the handset
battery pack should give about 12
hours talktime or 150 hours standby
on a single charge. (This does not
mean you can unplug the base station
or leave it for this length of time
without charge.)
Please note, however, that new NiCad
battery packs do not reach full
capacity until they have been in
normal use for several days.