BT Converse 2-line Telephone manual Connect the telephone Line cords, Connect the handset to Base

When replacing old batteries

If you have stored One-touch numbers and are replacing low batteries, you need to make sure that you maintain a power supply while the batteries are removed. You do this in order to retain the memory by taking the handset off the hook before removing the old batteries. Do not unplug the telephone line cords. Once the new batteries are in, you can replace the handset.

Battery low warning

When the display flashes LOW BATTERY, the HOLD button will not work until new batteries have been installed.

If the batteries go completely flat, any One-touch numbers that have been stored will be lost.

Connect the telephone

4line cords

Push the end of the cord with the transparent plug on it into the socket on the base unit. If you are connecting to one line only, use the L1 socket. If you are using both lines, use both L1 and L1/L2 sockets.

Plug the other end of the cords into the telephone sockets.

Connect the handset to

3the base

Plug one end of the coiled line cord into the handset and the other into the base.

Please note

When you pick up the handset, Line 1 is automatically selected. Therefore, when connecting to two lines, the telephone line cord connected to L1 should be plugged into the most frequently used line. This will save you having to press a Line button in order to answer the majority of calls. See ÔMaking and receiving callsÕ page 8Õ.

Set the connection

5mode switch

•If connecting to one telephone line only, set the Connection Mode switch to 1x.

•For two lines, set the Connection Mode switch to 2x.

6