BT RESPONSE75 manual Help

Response 75 – Edition 7 – 26th October ’00 – 3370

Help

If you have any problems using your Response 75, this section gives you the most common solutions

Call counter does not light up

Check that your Response 75 is correctly connected to the mains and that the power cable is inserted correctly into the back of your Response 75.

If you have inserted the back-up battery before connecting to the mains power you will need to reset your Response 75.

Response 75’s battery low indicator is on

The back-up battery is either low in power, missing or incorrectly installed. Open the battery compartment. If battery is correctly in place, try replacing it with a new 9V alkaline battery. When operating at normal power the battery light remains off.

No dialling tone

Check your line cord is correctly connected to the socket and your Response 75.

Response 75 display is flashing continuously

This indicates an error. Press any button on your answering machine. Flashing should stop and the answering machine should reset to its settings on first ‘power up’. Unplug the line cord and power cord. Wait 5 minutes and then replug.

Press the Answer on/off button on your answering machine. Flashing should stop and Response 75 should reset to settings on first ‘power up’.

Incoming message does not record

Make sure your Response 75 is set to answer-on mode and that the memory is not full. When the memory is full, the display will flash F.

You cannot hear messages or incoming calls

Your Response 75’s volume may be set too low. Adjust the volume by pressing

+on the volume control.

You experience a power cut

If a working battery is installed inside your Response 75, its settings and messages should be saved until power resumes. It will not be able to record any new messages, however.

21