Open Ofﬁce Environment | Buffalo Technology WBR2-G54S specs

Speciﬁcations

Modulation Technique Direct Sequence Spread Spectrum

•ODFM for High Transmit Rate

•DQPSK for Standard Transmit Rate

•DBPSK for Low Transmit Rate

Spreading 11-chip Barker Sequence

Nominal Output Power 13.5 dBm

Transmit Rate / Range

High Speed 54 Mbps (125 Mbps in 125 High Speed Mode)

Medium Speed 36 Mbps (96 Mbps in 125 High Speed Mode)

Standard Speed 2 Mbps

Low Speed 1 Mbps

Open Ofﬁce Environment

160 m (525 ft.)

270 m (885 ft.)

73

Image 73

Buffalo Technology WBR2-G54S user manual Open Ofﬁce Environment

Contents

WBR2-G54S Table of Contents Network Settings Table of Contents Introduction Introduction SOHO/SMB Networking Home Networking System Requirements AirStation WBR2-G54S Package Contents Product Views About the AirStation CD Installation / Setup Setup Overview Setup PreparationIntroduction Antenna Installation Open the Setup Screen Standard Settings DSL Button Enter ISP informationAutomatic IP Assignment by ISP PPPoE Connection Enter IP Address Manually Catv Cable Button Line Test Security Simple Security Setup Applications Refer to the on-screen help for Aoss Aoss Additional Aoss Information LAN Settings Advanced SettingsWireless Settings Wireless Function Enable or Advanced Settings Wireless LAN Security Advanced Settings Characteristics Advanced Settings LAN Port Dhcp Server Advanced Settings Manual IP MAC Address Assignment Settings Wireless PC’s Connection Wireless MAC Filter Register for Allowable PC’s MAC Address Wireless Bridge WDS Advanced Settings Wired WAN Performance WAN SettingsWAN Port Connection Type Select from MRU Maximum Receive MTU Maximum Transmit WAN Network Advanced Settings Routing Setup Network Settings Add Routing Table Entry Address Translation Enable or Disable . AddressIP Masquerade When Display/Delete NAT Table Add NAT Table Advanced Settings Log Output Select Output to Packet Filter Basic Filter Setting IP Filter Setting MAC Filter Click Enter MAC Lter to enter MAC address Click Apply when settings are complete DETECTOR@AIRSTATION Intrusion DetectorPage UPnP System Information Management Admin Name Password Select Use or Do not use Time setupNTP server name Enter Packet Trafﬁc Information Wired WAN Wired LAN Wireless LAN IP Address and Medium Client Monitor Ping Test Display log info Select Log InformationLog information Displays Log Information Level Syslog TransferLog Information Select Save current settings Click Save/Restore SettingsRestored saved settings Click Restart to reboot Reboot/Reload DefaultsAirStation Com/wireless Firmware UpdateFirmware ﬁle name Client Table Displays Aoss Manually specify the encryp Aoss Function Click Enable Power Characteristics Temperature & HumiditySpeciﬁcations Additional Information Radio Characteristics Networking CharacteristicsRegulatory Information Host Operating System Open Ofﬁce Environment Semi-Open Ofﬁce Environment 2412 Common Problems TroubleshootingLED Activity B Diag LED Activity Table B.1.1 Diag LED Activity Table Changing Client TCP/IP Settings in WindowsLEDs Work But Client PC Cannot Connect to Network Other Problems Cause ProblemRestrictions Proper Setup Click on the ‘LAN port’ link on the left Troubleshooting Troubleshooting Glossary Glossary MHz MegaHertz One million cycles per second ROM Read Only Memory Permanent memory PCI Peripheral Component Interconnect a Glossary Glossary Federal Communication Commission Interference Statement FCC / CE Information Federal Communication Commission Interference Statement Important Note EU Countries intended for use FCC RF Radiation Exposure StatementEU Countries Not intended for use Potential restrictive use Warranty Information General Inquiries Contact Information 4030 W. Braker Ln. Suite Austin, Texas Tel Fax