Bunn 10267 Electrical Requirements, Ce Requirements, Electrical Hook-Up, Dual Volt Toggle Switch

ELECTRICAL REQUIREMENTS

WARNING - The dispenser must be disconnected from the power source until specified in Initial Set-Up.

Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements.

WHITE	NEUTRAL WHITE		POWER CORD	L2 RED	NEUTRAL BLUE	POWER CORD
NEUTRAL		N			N
L1 BLACK		L1		L1 BLACK	L1 BROWN L1
	L1 BLACK

		GREEN	GREEN/YELLOW
	G			G
120 volt ac models
			230 volt ac models
Note: This electrical service con-			Note: This electrical service con-
sists of 2 current carrying conduc-			sists of 2 current carrying conduc-
tors (L1 and Neutral) and a separate			tors (L1 and Neutral) and a separate
conductor for earth ground.			conductor for earth ground.

Electrical Hook-Up

CAUTION – Improper electrical installation will damage electronic com- ponents.

1.An electrician must provide electrical service as specified.

2.Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.

3.Turn off master switch (if equipped).

4.Remove the upper and lower rear panels.

5.Install the proper electrical wiring to the terminal block.

6.Connect the dispenser to the power source and verify the voltage at the terminal block before proceeding. Reinstall both rear panels.

7.If plumbing is to be hooked-up later be sure the dispenser is discon- nected from the power source. If Plumbing has been hooked-up, the dispenser is ready for Initial Set-Up.

CE REQUIREMENTS

•This appliance must be installed in locations where it can be overseen by trained personnel.

•For proper operation, this appliance must be installed where the tem- perature is between 5°C to 35°C.

•Appliance shall not be tilted more than 10° for safe operation.

•An electrician must provide electrical service as specified in conformance with all local and national codes.

•This appliance must not be cleaned by water jet.

•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of this appliance by a person responsible for its safety.

•Children should be supervised to ensure they do not play with the ap- pliance.

• If the power cord is ever damaged, it must be replaced by the manufac- turer or authorized service personnel with a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.

• Machine must not be immersed for cleaning.

L2 RED	L2 RED	POWER CORD
		L2
L1 BLACK		L1
	L1 BLACK

GREEN

G

208 & 240 volt ac models

Note: This electrical service consists of 2 current carrying conductors (L1 and L2) and a separate conductor for earth ground.

L2 RED	L2 RED	POWER CORD
		L2
WHITE	NEUTRAL WHITE
NEUTRAL		N
L1 BLACK	L1 BLACK	L1

GREEN

G

120/208 & 120/240V ac

single phase models

Note: This electrical service consists of 3 current carrying conductors (Neutral, L1 and L2) and a separate conductor for earth ground.

DUAL VOLT TOGGLE SWITCH

5 46819 043012