SERVICE (cont.)
BALLAST |
|
FIG. 4 BALLAST | P1445 |
| |
Location |
|
The front door lamp ballast is located behind the front access panel on the left side of the compo- nent bracket.
Test Procedure
1.Disconnect the dispenser from the power source.
2.Disconnect the two terminal plug of the door interconnect harness from the main wiring har- ness.
3.Check the voltage across the white wire and the blue wire terminal of the ballast with a voltmeter. Connect the dispenser to power source. The indi- cation must be:
a)120 volts ac for two wire 120 volt models.
b)120 volts ac for three wire 120/208 volt models or 120/240 volts models.
c)240 volts ac for two wire 240 volt models.
If voltage is present as described the ballast is oper- ating properly.
If voltage is not present as described, replace the ballast.
Removal and Replacement
1.Disconnect the wires from the ballast.
2.Remove the one
3.Remove and discard ballast.
4.Install new ballast over the weld pin on the com- ponent bracket and secure with one
5.Refer to Fig. 5 when reconnecting the wires.
BLK to Main Wiring |
|
Harness |
|
BLK to BLU |
|
from Door |
|
Interconnect |
|
Harness |
|
FIG. 5 BALLAST TERMINALS | P1447 |
|
15 | 28364 011598 |
|
