PROGRAMMING THE BREWER (cont.) PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

15.The display should now read DRIP TIME, along with either the word OFF or a time showing. A batch light will also be blinking.

16.Using (-)and (+), set the amount of time from when the brew spray ends to when the funnel is emptied of hot liquid.

17.When finished, press the other batch size and repeat step #16

18.When finished setting both batch sizes, pressDONE. The display should read 2 BATCHES DONE?

19.Press and release YES.The screen should show the name of the coffee being programmed (modified) along with SETUP COMPLETE.

20.After a 5 second delay, the display will advance to the next coffee name in the brewer’s memory. If no other coffee names are present, the display will read THAT WAS THE LAST RECIPE, and advance to the MASTER TEMP screen.

SET NEW RECIPE

Using a RECIPE CARD to load coffee names and brew settings

The G9-2T DBC or MHG Grinder’s memory contains certain coffee names. If the operator uses a coffee name that is not already stored in the grinder’s memory, a RECIPE CARD can be obtained from the factory. The RECIPE CARD would include all the information needed to set up that particular coffee name. The information from the RECIPE CARD is loaded into the grinder’s memory, then into the brewer’s memory by holding the chip area up to the equipment’s SENSING COIL. This information can include the coffee name, BREW VOLUMES, PULSE BREW TIMES and DRIP OUT TIME for that particular coffee name. These can all be loaded in seconds.

Contact Bunn-O-Matic Corporation for the availability

of RECIPE CARDS.

NOTE: Instructions to program the brewer and grinder are printed on the RECIPE CARD, along with the coffee name that is being programmed.

Procedure to program the coffee name:

1.Remove the funnel (if present) from the funnel rails.

2.Position the RECIPE CARD vertically, so that the top end of the CHIP is beneath the SENSING COIL (located on the middle of the underneath side of the front display panel).

3.After a short pause the display will read CARD CON- TAINS RECIPE FOR then will change to (COFFEE NAME) SHOW QUIT SAVE. All brewing parameters for that coffee flavor are now transferred from the CARD to the brewer.

READY TO BREW

WATER TEMP: 205°

POSITION CARD UNDER

SENSOR COIL

CARD CONTAINS

RECIPE FOR

5 SEC.

(COFFEE NAME) SHOW QUIT SAVE

BREW

BREW

BREW

A

B

C

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SCROLLS THROUGH

 

 

(COFFEE NAME)

ALL BREW SETTINGS

 

 

FOR THAT RECIPE

 

 

SETUP COMPLETE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

(COFFEE NAME)

NOT SAVED

READY TO BREW

WATER TEMP: 205°

P2856

Page 24

36748 101505