Bunn FPG G9 WD - Packaging & Shim Removal, See Instructions Below Before Using, housing. Figure

G9 WD - Packaging & Shim Removal

WARNING

MUST BE COMPLETED BY AUTHORIZED SERVICE PERSONNEL.

DO NOT PLUG IN !

SEE INSTRUCTIONS BELOW BEFORE USING !

Step 1 - Remove & discard tape holding funnel arm in place. (Figure 1) Step 2 - Remove & discard two silicon tubes between funnel guide &

housing. (Figure 2)

Step 3 - Remove four screws in front housing panel. (Figure 3) Step 4 - Remove & discard shim under transducer. (Figure 4) Step 5 - Replace housing panel and secure four screws. (Figure 3)

Figure 1

Figure 2

Figure 3

Figure 4

5 41545 111711