Bunn LPG-2, G9WD, G9-2T DBC, FPG Urn/Carafe Switch Models G9, G9-2, URN/CARAFE Switch Terminals

SERVICE (Cont.)

Urn/Carafe Switch (Models G9, G9-2)

URN

ON

O	S
	T
F	A
F	R
	T

CARAFE

FIG 30 URN/CARAFE SWITCH P1300

Location:

The Urn/Carafe switch is located to the left side on the front of the housing above the upper inspection panel.

Test Procedure:

1.Disconnect the grinder from the power supply.

2.Remove the tan, yellow and green wires from the switch.

3.Place the switch in the “CARAFE” position; check for continuity across the pink and the tan wire terminals, also across the orange and the yellow wire terminals.

If continuity is present as described in both checks, proceed to step 4.

If continuity is not present as described in one or both of the checks, replace the switch.

4.Place the switch in the “URN” position; check for continuity across the orange and green wire ter- minals.

If continuity is present as described, the switch is operating properly.

If continuity is not present as described, replace the switch.

Removal and Replacement:

1.Remove all the wires from the switch terminals.

2.Compress the clips inside the housing and gently push the switch through the opening.

3.Push the new switch into the opening and spead the clips to hold the switch in the housing.

4.Refer to the illustration below when reconnecting the wires.

TAN YEL

PNK ORA

GRN

P1318

P1318

FIG 31 URN/CARAFE SWITCH TERMINALS

35 41545 122209