SERVICE (cont.)
AUGER SHAFT ASSEMBLY(cont.)
Open face of seal away from tool
Cooling Drum Seal
Seal Insertion Tool
P1760
FIG. 7 COOLING DRUM SEAL
14.Assemble motor/shaft assembly as shown in Fig. 8, then install assembly into cooling drum. Make sure the pins do not hit the sensor board and cool- ing drum seal is not dislodged as the shaft passes through.
Lube about 1 1/2” of shaft and in the groove with #29563.0000 “Krytox” Lubricant
Auger Shaft Assy
P1761
FIG. 8 MOTOR/SHAFT ASSEMBLY
15.Secure motor and capacitor to the cooling drum mounting bracket. Install rear motor cover.
16.Refer to Hopper Installation for hopper assembly and installation procedures. Be sure to use new hopper/drum seal and faucet seals
FIG 9 |
17.Remove and clean condenser air filter, Fig. 10.
18.Refer to the Programming Manual, “Menu Function Index”. Scroll to menu “PM Complete?” and answer “YES” to reset the reminder message “PM Due”.
P3682 |
FIG 10 |
26 | 41084 102709 |
|