Figure 53: Boiler Flueway Cleaning
F.Clean Combustion Chamber by vacuuming. Exercise care to avoid damaging Base Insulation.
G.Install Burners by reversing procedures used to remove burners. Verify Main Burners are properly located on support bracket in Base Rear Panel, seated on Main Burner Orifices, and secured with hitch pin clips. Verify Main Burner with Pilot Bracket is in proper location. See Table 13.
H.Lubrication. Manufacturers Instruction should be followed on all parts installed on boiler requiring lubrication. This includes type of lubricant to be used, frequency of lubrication, and points to lubricate.
I.Check operation. Refer to Section VIII: System Start- up.
Table 13: Pilot Burner Location
Boiler Model | Pilot Located Between Burners* |
805H | 4 & 5 |
806H | 5 & 6 |
807H | 6 & 7 |
808H | 6 & 7 |
809H | 7 & 8 |
810H | 8 & 9 |
*Burners numbered left to right as viewed from front of boiler.
63
