Vehicle Installation
Installing the Vent Mount:
1Locate a vent with horizontal louvers sturdy enough to hold your PowerConnect Vehicle Dock and radio..
3Push the Vent Mount onto the vehicle vent as shown (1) until it hooks on the rear of the vent louver (2)..
4Rest the foot against the bottom of the vent (2), and adjust the tilt of the Vent Mount by repositioning the foot to a different adjustment hole (3)..
2 If the vent louvers in your vehicle are recessed, you may need to use
the longer vent clamps with the Vent Mount.. If so, remove the shorter vent clamps and install the longer ones
into the Vent Mount.. Be sure to observe the orientation of the vent clamps as shown..
Remove End Cap Slide Short Vent Clamps Out
1
Dash
PUSH 
Vent
Foot
Louver
23
Dash |
| Dash |
| HOOKED |
|
| Vent | Vent |
|
| |
| TILT |
|
| ADJUSTMENT |
|
| HOLES |
|
Slide Extended Vent Clamps In | Replace End Cap |
To remove the Vent Mount, push the mount into the vent.. Then lift up until disengaged from the rear of the vent louver, and remove the Vent Mount..
18 | 19 |
