Vehicle Installation
Step 2: Install the Dash or Vent Mount
Depending on your situation, you can either choose to use the Dash Mount or the Vent Mount..
IMPORTANT! When you install the chosen mount, do not attach the dock to the mount.. All cables should be attached to the dock prior to connecting the dock to the mount..
Installing the Dash Mount:
CAUTION! The adhesive used on the Dash Mount may be difficult to remove.. Do not install this mount on leather surfaces and make sure the air temperature is at least 15˚C (60˚F) during installation..
1Locate a flat surface for the Dash Mount.. Make sure there is ample room for the PowerConnect Vehicle Dock and onyX Radio when installed..
2Set the orientation of the Dash Mount before adhering it.. Loosen the
knob and adjust the adhesive foot for the location you selected in “Step 1: Choose a
Location for Your | I | II |
Radio” on page 14.. |
|
|
•Option 1 & 3 should be oriented as I..
•Option 2 should be oriented as II..
3The dock mounting plate can be tilted in different directions.. Adjust as necessary for your particular vehicle.. When the orientation is correct, tighten the knob..
Knob | Adhesive Foot | Dock Mounting Plate |
4Clean the surface with the
alcohol preparation pad and let it dry thoroughly..
5 Peel off the adhesive liner.. Position, press, and hold the Dash Mount in place for 30 seconds..
IMPORTANT! Once the mount is attached to the dash, let the adhesive cure (dry) for 24 hours before attaching the dock and radio to the mount..
TIP! To remove, carefully lift the adhesive pad with your fingers or a spoon.. Warming the pad with a hair dryer for several minutes will help soften the adhesive..
16 | 17 |