ASSEMBLY
RMB 1445 11/10 Assembly Section 3-5
© 2010 Alamo Group Inc.
ASSEMBLY
DEALER SETUP INSTRUCTIONS
1. The machine is delivered in a partially assembled. To make ready for attachment to the tractor it will be
necessary to select a hard level surface
2. Cut the banding straps and remove loose items and the stabilizer. Leave the transport straps on at this
stage.
STABILIZER ATTACHMENT
Fit the stabilizer nose into the tractors top link
position (A). Use the highest position available,
avoiding any load sensing properties. The bolt on
nose of the stabilizer is reversible to accommodate
a variety of tractor linkage designs.
Stretch out the stabilizer and bolt to the machine
using the holes farthest from the tractor that the
stabilizer will reach (B). Do not fully tighten bolts at
this stage and do not replace the stabilizer nose
quadrant pin. (Figure ASM-B-0085)