Nº53 Power Amplifier
Material Requirements
Note
Network Setup
The Nº53 reference power amplifier supports network connection through the Ethernet port. The Nº53 can connect to a network through use of a router or directly to a computer.
The Nº53 can be:
1.Connected to a router with DHCP active – We highly recommend using this option. Since the DHCP (Dynamic Host Configuration Protocol) automatically assigns the IP (Internet Protocol) addresses, setup is much simpler.
2.Connected to a router with DHCP not active – This method requires more advanced networking knowledge to set up because it uses fixed static IP addressing.
3.Connected directly to a computer with no router – We recommend only using this option when a router is not available. This method requires more advanced networking knowledge to set up because it uses fixed static IP addressing and a special network crossover cable.
This section provides general instructions for all three methods.
13
The following materials are required to connect the Nº53 to the network with a router:
•Nº53 reference monaural power amplifier
•Two
•
•10/100BaseT router
The Nº53 does not support wireless connection. However, a cable attached from the amplifier to a wireless adapter can be used to interface with a wireless network.
The following materials are required to connect the Nº53 to a computer without the use of a router:
•Nº53 reference monaural power amplifier
•Network crossover cable
•