Nº53 Power Amplifier
No Power (Standby LED is off)
No Output
Troubleshooting
Incorrect operation is sometimes mistaken for malfunction. If problems occur, use this section for troubleshooting information. If problems persist, contact your authorized Mark Levinson dealer.
1.Examine the power cord to ensure that it is connected to both the rear panel connector of the Nº53 and an electrical outlet.
2.Make sure the Nº53 is powered on with the rear panel Power switch.
3.Examine the electrical circuit breaker to ensure that power is being supplied to the electrical outlet to which the Nº53 is connected.
4.Verify that the voltage rating on the rear panel of the Nº53 matches the voltage rating of the electrical outlet. If the voltages do not match, no power is sent to the outputs of the amplifier.
1.Make sure that the source device is powered on, playing audio, and set to the right output connector.
2. Make sure the Nº53 is not in Standby or Power Save mode. The | 25 |
LED should be at full brightness. |
|
3.Examine cables to ensure a solid connection between the Nº53 and associated components.
4.Make sure the Nº53 output connectors are connected to operational loudspeakers.
5.Ensure that the Nº53 is not in a fault condition. When the Nº53 experiences a fault, the output is muted and the Status LED on the front panel blinks in a rapid pattern, indicating:
LED Behavior | Description |
|
|
Rapidly blinking | Indicates that a |
(on most of the time) |
|
|
|
Rapidly blinking | Indicates that a |
(on half of the time) |
|
|
|
Rapidly blinking | Indicates that a |
(off most of the time) | occurred. |
|
|
In fault mode, the amplifier output is muted and the main power supply is shut down. The Nº53 remains in fault mode until the fault condition is resolved and the amplifier is