Nº53 Power Amplifier
Note
Direct Connection
8.Observe that the Status section of the Web page identifies the host name of the amplifier. The host name can be modified, but only the first eight characters are affected; anything after the underscore may not be modified.
To change the host name of the amplifier:
A.Type the new name into the white box to the right of the parameter. The new name must be made from the capital letters, A to Z, and the numbers, 0 to 9. Underscores may also be used. Only eight characters are allowed.
The host name MUST start with an
B. Click the Submit button to save the new value.
C. Click the Refresh button in the Status section of the Web page to observe the new host name.
9.Observe that the Status section of the Web page also identifies the IP address of the amplifier. The static IP address can be modified, if desired.
To change the IP address of the amplifier:
19
A. Type the new IP address into the white box to the right of the parameter.
B. Click the Submit button to save the new value.
C. Enter the new IP address of the amplifier into the browser. The amplifier Web page loads, reflecting the new information.
The network connection is now complete.
Use this procedure to connect directly to a computer if you are not using a router. For the computer to find the amplifier, the TCP/IP and LAN settings of the computer must be set up. Refer to the earlier “Setting up the Computer” procedure for instructions.
1.Connect the amplifier to the computer, as described in the earlier “Connecting the Cables” procedure. Make sure that both the amplifier and the computer are powered off before connecting.
2.Press the Power button on the amplifier.
3.On the computer, open the Internet Explorer Web browser.
4.On the address (URL) line, type in the static IP address of the amplifier and press Enter. There may be a short delay before the amplifier Web page loads.
