3.4 Powering on and Entering into the ON (Live) Mode (continued)
In the above three modes the OFF mode is the specified safe mode when any actions must be taken, e.g., replacing the
Entering into the ON (Live) mode: After turning on the BUSHNELL TROPHY CAM , it will enter into the ON mode. The motion indication LED (red) will blink for about 10s. This time interval is for you to make the BUSHNELL TROPHY CAM ready for operation, e.g., to close the front cover and to lock it. After entering into the ON mode, no manual controls are needed or possible. The BUSHNELL TROPHY CAM will take pictures or videos automatically according to the previous programmed settings, when activity is detected in the monitoring region.
If the device was previously in the SETUP mode, you just need to slide the switch to the ON position.
3.5Activating the LCD screen and Entering into the SETUP Mode Entering into the Setup (Test) mode: Anytime in the SETUP mode, the SETUP mode is activated by moving the slide switch to the SETUP position (If a picture or a video is just being taken, this action will be finished first).
Under the Setup mode you can change the settings of the BUSHNELL TROPHY CAM manually or set operational parameters with the help of the
3.6Manual Capture
Under the SETUP mode, you just need to aim at the object, and then press the SHOT key. A few seconds later, you’ll get a picture saved in the SD- card. The number of pictures and video clips at the bottom of the LCD will increase by one.
3.7 Default Settings and Live Monitoring
When the BUSHNELL TROPHY CAM leaves the factory, most parameters are set as default. Please refer to table 1.
8
