C. Crane CCRadio plus Timer Activation Switch, To SET the on Time, To SET the OFF Time

through the other source. You can still listen to the CCRadio plus while using the LINE OUT jack.

TIMER ACTIVATION SWITCH

The black jack labeled with this symbol is for use with a recorder that has a timer activated switch. You would use this switch if you wanted to do a timed recording. It is used in conjunction with the LINE OUT jack. See your recorder for specific instructions.

SETTING THE TIMER

Please read this entire page carefully before you start. You will need to go through the 3 steps listed below without stopping. If you stop for more than 15 seconds, you will need to press and hold the Timer Button until you hear a single beep. Then start at step one again.

Before you begin, program the stations that you will want to record into memory. Refer to page 13 for instructions on programming memory pre- sets. The timer has an ON TIME and an OFF TIME. You must set both in order for the timer to work correctly.

STEP 1: TO SET THE ON TIME

1)Press and hold the Timer/Set Button until you hear a double beep and the word ON, the hour digit and TIMER flash on the display.

2)Use the Tuning Up/Down Buttons to set the hour, verifying that the time is set correctly for AM or PM as shown on the display.

3)Press the Timer/Set Button again so the minutes and the word ON and TIMER flash on the display.

4)Use the Tuning Up/Down Buttons to set the minutes.

STEP 2: TO SET THE OFF TIME

1)Press the Timer/Set Button again until the word OFF, the hour digit and TIMER flash on the display.

2)Use the Tuning Up/Down Buttons to set the hour. Again, verify that the time is set correctly for AM or PM.

3)Press the Timer/Set Button again so the word OFF and TIMER and the minutes, flash on the display.

4)Use the Tuning Up/Down Buttons to set the minutes.

STEP 3: TO SET THE FREQUENCY

1)Press the Timer/Set Button again to select your desired frequency. The word TIMER and the memory preset will flash on the display. Using the Band Button, select the appropriate band (AM, FM, TV or WX). Press the memory button 1-5 that corresponds with your desired station.

2)You must Press the Timer/Set Button again to complete the setup.

Page 18