NOTICE
Cabletron Systems reserves the right to make changes in specifications and other informa-
tion contained in this document without prior notice. The reader should in all cases consult
Cabletron Systems to determine whether any such changes have been made.
The hardware, firmware, or software described in this manual is subject to change without
notice.
IN NO EVENT SHALL CABLETRON SYSTEMS BE LIAB L E FO R AN Y I NC ID EN T AL, IN DI-
RECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHA TSOEVER (INCLUDING BUT
NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR
THE INFORMATION CONTAINED IN IT, EVE N IF CABLETRON SYS TEMS HAS BEEN
ADVISED OF, KNOWN, OR SHOULD HAVE KNO WN, THE POSSIBILITY OF SUCH DAM-
AGES.
© Copyright 1999 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005
All Rights Reserved
Printed in the United States of America
Part Number: 9032579-03 January 1999
ELS100-24TX is a trademark of Cabletron Systems, Inc.
All other product names mentioned in this manual may be trademarks or registered trade-
marks of their respective companies.
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is subj ect to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, incl uding i nterf erence that may cause und esired oper ation.
NOTE: This equipment has been tested and found to comply wit h the limit s for a Clas s A dig-
ital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide rea-
sonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment uses, generates, and can radiate radio frequency
energy and if not installed in accordance wi th the op erator’s man ual, may cause har mful inter-
ference to radio communications. Operation of this equipment in a residen tial are a is likely to
cause interference in which case the user will be required to correct the interference at his
own expense.
WARNING: Changes or modifications made to this device which are not expressly approved
by the party responsible for compliance could void the user’s authority to operate the equip-
ment.
Printed on Recycled Paper
Only qualified personnel should perform installation
procedures.