Cabletron Systems FDDI Repeater manual Installing the MicroLAN Module, Unpacking the Module

Chapter 2

Installing the MicroLAN Module

This module uses FPIMs for the front panel connections. They are not shipped with the module and must be purchased separately. For more information on FPIMs see Appendix A.

Unpacking the Module

1.Carefully remove the module from the shipping box. (Save the box and packing materials in the event the module must be reshipped.)

2.Remove the module from the plastic bag. Observe all precautions to prevent damage from Electrostatic Discharge (ESD).

3.Carefully examine the module, checking for damage. If any damage exists, DO NOT install the module. Contact Cabletron Systems Technical Support immediately.

Installing an FPIM

FPIMs are required for the 9F206-02 and are ordered and shipped separately. To install an FPIM, follow the procedure below:

1.Remove the module if it is installed in the MMAC-Plus chassis.

2.Remove the blank front cover over the FPIM slot.

3.Install the FPIM as shown in Figure 2-1.Ensure that the rear connector is seated firmly before tightening the two mounting screws.

2-1