Laser Radiation and Connectors | Cabletron Systems FDDI Repeater

Notice

Safety Information

CLASS 1 LASER TRANSCEIVERS

Laser Radiation and Connectors

When the connector is in place, all laser radiation remains within the ﬁber. The maximum amount of radiant power exiting the ﬁber (under normal conditions) is -12.6 dBm or 55 x 10-6watts.

Removing the optical connector from the transceiver allows laser radiation to emit directly from the optical port. The maximum radiance from the optical port (under worst case conditions) is 0.8 W cm-2or 8 x 103 W m2 sr-1.

Do not use optical instruments to view the laser output. The use of optical instruments to view laser output increases eye hazard. When viewing the output optical port, power must be removed from the network adapter.

iv

Image 5

Cabletron Systems FDDI Repeater manual Laser Radiation and Connectors

Contents

MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page DOC Notice FCC Notice Class 1 Laser Transceivers Safety Information Laser Radiation and Connectors Contents Introduction Features Lanview LEDs 9F206-02 Getting Help Related Manuals Unpacking the Module Installing the MicroLAN ModuleInstalling an Fpim Installing an Fpim User-Accessible Components User-Accessible Components Location of Module DIP Switch Setting the Module Card DIP Switch Switch Function Description Off Factory Default Function of DIP Switch Installing the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset Switch Flexible Network Bus FNB Operation System Management Bus System Diagnostic ControllerDC/DC Converter FNB Interface CPU F206-02 Lanview Lanview LEDs LED Color State Description SMB and CPU LEDs Fddi Status LEDs Fddi Port Status LEDsLED Color LED Color State General Speciﬁcations SafetyService Physical FPIM-00 and FPIM-01 Fpim SpeciﬁcationsTable A-1. FPIM-00 and FPIM-01 Speciﬁcations Parameter Typical Value Worst Worst Case Budget FPIM-02 and FPIM-04 Table A-2. Transmitter Power ParametersTable A-3. FPIM-04 Pinouts Pin Number Represents Parameter Typical Minimum Maximum FPIM-05 and FPIM-07Table A-4. FPIM-05 and FPIM-07 Speciﬁcations