FPIM-05 and FPIM-07 | Cabletron Systems FDDI Repeater guide

FPIM-05 and FPIM-07

FPIM-05 and FPIM-07

The FPIM-05 and FPIM-07 provide a Single-mode ﬁber connection. The FPIM-05 uses a MIC style connector and the FPIM-07 uses an SC type connector. The speciﬁcations for both devices are listed in Table A-4.

Table A-4. FPIM-05 and FPIM-07 Speciﬁcations

Parameter	Typical	Minimum	Maximum


Transmitter Peak Wave	1300 nm	1270 nm	1330 nm
Length

Spectral Width	60 nm	-	100 nm

Rise Time	3.0 nsec	2.7 nsec	5.0 nsec

Fall Time	2.5 nsec	2.2 nsec	5.0 nsec

Duty Cycle	50.1%	49.6%	50.7%

Bit Error Rate	Better than 10-10

The link distance is up to 40 kilometers (max) and 25 kilometers (typical) on single mode ﬁber-optic cable as speciﬁed by ANSI SMF-PMD.

A-3

Image 29

Cabletron Systems FDDI Repeater manual Table A-4. FPIM-05 and FPIM-07 Speciﬁcations, Parameter Typical Minimum Maximum

Contents

MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page DOC Notice FCC Notice Class 1 Laser Transceivers Safety Information Laser Radiation and Connectors Contents Introduction Features Lanview LEDs 9F206-02 Getting Help Related Manuals Unpacking the Module Installing the MicroLAN ModuleInstalling an Fpim Installing an Fpim User-Accessible Components User-Accessible Components Location of Module DIP Switch Setting the Module Card DIP Switch Switch Function Description Off Factory Default Function of DIP Switch Installing the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset Switch Flexible Network Bus FNB Operation System Management Bus System Diagnostic ControllerDC/DC Converter FNB Interface CPU F206-02 Lanview Lanview LEDs LED Color State Description SMB and CPU LEDs Fddi Status LEDs Fddi Port Status LEDsLED Color LED Color State General Speciﬁcations SafetyService Physical FPIM-00 and FPIM-01 Fpim SpeciﬁcationsTable A-1. FPIM-00 and FPIM-01 Speciﬁcations Parameter Typical Value Worst Worst Case Budget FPIM-02 and FPIM-04 Table A-2. Transmitter Power ParametersTable A-3. FPIM-04 Pinouts Pin Number Represents Parameter Typical Minimum Maximum FPIM-05 and FPIM-07Table A-4. FPIM-05 and FPIM-07 Speciﬁcations