Lanview LEDs | Cabletron Systems FDDI Repeater specs

Introduction

LANVIEW LEDs

The 9F206-02 uses LANVIEW: the Cabletron Systems built-in visual diagnostic and status monitoring system for at-a-glance diagnosis of the network. With LANVIEW LEDs, you can quickly identify the device, port, and physical layer status.

Hot Swapping

The 9F206-02 can be installed or removed from the chassis while the MMAC-Plus is powered up without affecting the operation of the rest of the system.

1-2

Image 8

Cabletron Systems FDDI Repeater manual Lanview LEDs

Contents

MMAC-Plus9F206-02 Fddi Repeater MicroLAN Module User’s Guide Page FCC Notice DOC Notice Safety Information Class 1 Laser Transceivers Laser Radiation and Connectors Contents Features Introduction Lanview LEDs 9F206-02 Related Manuals Getting Help Unpacking the Module Installing the MicroLAN ModuleInstalling an Fpim Installing an Fpim User-Accessible Components User-Accessible Components Setting the Module Card DIP Switch Location of Module DIP Switch Function of DIP Switch Switch Function Description Off Factory Default Installing the Module into the MMAC-Plus Chassis Installing the MicroLAN Module Reset Switch Reset Switch Operation Flexible Network Bus FNB System Diagnostic Controller System Management BusDC/DC Converter FNB Interface CPU Lanview LEDs F206-02 Lanview SMB and CPU LEDs LED Color State Description Fddi Port Status LEDs Fddi Status LEDsLED Color LED Color State General Speciﬁcations SafetyService Physical Fpim Speciﬁcations FPIM-00 and FPIM-01Table A-1. FPIM-00 and FPIM-01 Speciﬁcations Parameter Typical Value Worst Worst Case Budget Table A-2. Transmitter Power Parameters FPIM-02 and FPIM-04Table A-3. FPIM-04 Pinouts Pin Number Represents Parameter Typical Minimum Maximum FPIM-05 and FPIM-07Table A-4. FPIM-05 and FPIM-07 Speciﬁcations