Using the FRX4000, FRX6000, and SmartSwitch 1800 Hub View
2-14 Monitoring Hub Performance
disa (disabled) The port is operationally disabled.
disc (disconnect) One of the two endpoints connected via the port has
closed the connection.
conf (conÞgured) The port has been conÞgured in the database, but the
conÞgured protocol has not been installed on the
associated RLP card.
dial (dialReady) For a frame relay port, this state indicates that the port
has been conÞgured as a backup port, and it is ready to
be switched into use if needed; for an X.25 port, this state
indicates that the port is ready to transmit or receive
calls.
quies (quiesced) A port which has been quiesced will be disabled when all
active calls have been completed. No new calls can be
initiated during this delayed disable state. Once a
quiesced port is disabled, it will remain disabled until it
is enabled by management action.
fail (failed) The port has failed due to a broken cable or other wire
problem, either while moving to the operational state or
after achieving it.
fault (hardware fault) Indicates that the port has failed due to a hardware
problem on the serial port itself.
na Not applicable; this value displays for any LAN ports
installed in the device.
other The port status response received from the device was
not understood by SPMA.
ipl The port is in a booting state (initial program load). This
is a very brief transitional state that is unlikely to be
displayed.
restar (restarting) A very brief transitional state that occurs during boot up;
this state is unlikely to be displayed.
onhook Indicates there is no call in progress and the voice port is
able to accept an incoming call.
offhook Indicates there is a call in progress and the voice port is
not able to accept an incoming call.
dialing Indicates a call is being placed but has not been accepted
yet.
active Indicates a call has been placed and answered.
pending The device at the remote end has been placed onhook
while the call was still in progress.