INSTALLATION
If you disconnect one end of a HubSTACK Interconnect cable and leave the other end attached to the hub, ensure that you disconnect the cable from the “OUT” port as shown in Figure
Disconnect SEH and SEHI Interconnect Cables
at the "OUT" Port.
OUT
SEH INTERCONNECT 
IN
OUT
SEH INTERCONNECT 
IN
SEH INTERCONNECT
OUT
Figure 3-2. Disconnecting the HubSTACK Interconnect Cable
3.2.2Attaching the Strain Relief Bracket
Attach the strain relief bracket to the front of the SEH as follows:
1.Locate the strain relief bracket and four
Warning: Use of longer screws may cause damage to the unit or electrical shock.
2.Attach the strain relief bracket to the bottom of the SEH as shown in Figure
HubSTACK
Figure 3-3. Attaching the Strain Relief
Page
