Cal Spas LTR20111000 Electrical Power Efficiency, Jets, OperatingYour, LED Perimeter Lighting

20

Spa

Electrical Power Efficiency Jets

OperatingYour

Your new spa comes equipped with an electric heater. Following the directions listed below will ensure the most efficient operation:

NOTE: This method is only for spa usage under two hours a week.

•Keep the spa’s operating temperature 5˚F below the desired usage temperature when not in use. One or two hours before use, set the temperature to the desired temperature.

•If the spa usage exceeds two hours a week, the set temperature should remain at the desired usage temperature.

•The air venturis should be used sparingly. When open, water temperature drops quite rapidly and can also dissipate chemicals.

Allowing the water temperature to lower more than 10˚F below the desired usage temperature and reheating it prior to usage will cause the heater to operate longer than it normally would maintaining the desired temperature. Doing this will increase your operating cost and makes your heater work more than necessary.

Almost all of the jets in your spa are adjustable. Rotating the face of an adjustable jet to the left (counter-clockwise) will decrease the amount of water flow through the jet. Rotating the face of an adjustable jet to the right (clockwise) will increase the amount of water flow through the jet. (See example shown below.)

Neck jets adjust in the opposite directions (counter- clockwise to increase, clockwise to decrease).

LED Perimeter Lighting

Press the LIGHT button on the topside control panel to turn the spa light on. If your spa has perimeter LED lights, they will also light up at the same time as the spa light.

The perimeter lights operate in three modes:

1.Cycle: The first time you press the LIGHT button, the lights will cycle through all the colors in this order:

White

Cyan

Magenta

Blue

Yellow/green

Green

Red

To cycle through the different color choices, press the button repeatedly. Each time you press the button, you advance to the next color.

2.Flashing white: When you have cycled through all the colors, the next time you push the LIGHT button, the LED lights will flash white.

3.Fading cycle: The next time you push the LIGHT button, the lights will gradually fade from one color to the next in the order shown above.

Spas with exterior corner LED lighting work in the same modes as described above but do not light up when the interior perimeter lights are yellow/green, green or red.

2011 Portable Spa

www.calspas.com LTR20111000, Rev. D