4
Preparing forYour New Portable Spa
Preparing a Good Foundation
Your spa needs a solid and level foundation. The area that it sits on must be able to support the weight of the spa, with water and the occupants who use it. If the foundation is inadequate, it may shift or settle after the spa is in place, causing stress that could damage your spa shell and finish.
Damage caused by inadequate or improper foundation support is not covered by the warranty. It is the responsibility of the spa owner to provide a proper foundation for the spa.
Place the spa on an elevated 3” - 4” concrete slab. Pavers, gravel, brick, sand, timbers or dirt foundations are not adequate to support the spa.
We strongly recommend that a qualified, licensed contractor prepare the foundation for your spa.
If you are installing the spa indoors, pay close attention to the flooring beneath it. Choose flooring that will not be damaged or stained.
If you are installing your spa on an elevated wood deck or other structure, it is highly recommended that you consult a structural engineer or contractor to ensure the structure will support the weight of 150 pounds per square foot.
To properly identify the weight of your new spa when full, remember water weighs 8.33 lbs. per gallon. For example, an average 8’ spa holds approximately 500 gallons of water. Using this formula, you will find that the weight of the water alone is 4,165 lbs. Combined with the dry weight of the spa you will note that this spa will weigh approximately 5,000 lbs. when full of water.
2011 Portable Spa
www.calspas.com | LTR20111000, Rev. D |
