28Cal Clarity II Bromine Generator
Water Clarity
The Cal Clarity II bromine generator automatically generates and releases free bromine into the spa water. You will still need to test for bromine and occasionally adjust it to return the bromine level to the baseline.
Do not use the Cal Clarity II bromine generator with a UV sanitation device.
Starting the Spa with Fresh Water
This applies to spa owners with the Cal Clarity II bromine generator ONLY.
Prior to filling a spa for the first time, or after a routine draining, you will want to follow this
1.Fill the spa to the proper water level with normal tap water. (Do not use soft water.) See page 9 for filling instructions.
2.Turn on the spa and allow it to prime. See page 11 for priming instructions..
3.Turn on the jets.
4.Press the Boost button to turn on the Cal Clarity II system. The red
ON light should appear steady. If it blinks, make sure the jets are running.
Indicates when bromine |
|
is being generated | TDS level indicators |
|
Diagnostics Mode |
|
|
ON / OFF / Boost Maintenance Mode | UP | DOWN |
5.Press and hold the Prog button for two seconds.
When the flashing number appears, press the
Prog button a second time. An animation will appear, then a number showing the total dissolved solids (TDS) level will be shown.
6.Add Bromicharge™ to the spa water. Use the table below to determine how much you should use.
7.Let the spa run for 15 minutes. Leave it uncovered during this time.
8.Check the TDS level again (described in step 7).
9.Set the Maintenance level. Press and hold the Prog button for two seconds. A number will flash showing the Maintenance Mode bromine level. Press the UP or DOWN buttons to raise or lower it. Press the Boost button to return Maintenance Mode.
Use the table below to determine which level to start at.
Spa capacity (gallons) | Maintenance level |
|
|
300 - 400 | 10 |
|
|
400 - 500 | 15 |
|
|
> 500 | 20 |
|
|
Spa Capacity | Amount of | |||
BromiCharge™ | ||||
|
| |||
Gallons | Liters | Pounds | Kilograms | |
|
|
|
| |
300 | 1135 | 3.6 | 1.6 | |
|
|
|
| |
400 | 1515 | 4.8 | 2.2 | |
|
|
|
| |
450 | 1700 | 5.4 | 2.5 | |
|
|
|
| |
500 | 1890 | 6 | 2.7 | |
|
|
|
| |
10.Put cover on spa and let spa run for 24 hours to allow it to heat to desired temperature.
11.After 24 hours, check TDS level again (as described in step 7). TDS should be between 3 -
5 ppm. If it is too low, raise it in increments of 5 (as described in step 11).
Use 1.2 lbs. per 100 gallons, or .5 kg per 378 liters.
2011 Portable Spa
www.calspas.com | LTR20111000, Rev. D |
