CHN50300

Operation

Project Materials List:

 

 

u Wood Flooring

u Flooring Fasteners (L-Cleats or staples)

u Finish Nails

u Underlayment

u Tape

Project Tools List:

 

 

u Flooring Nailer

u Finish Nailer

u Circular / Miter Saw

u Jig Saw

u Air Compressor

u Air Hose

u Drill

u Drill Bits

u 30 W Non-Detergent Oil

u Tack Hammer

u Pry Bar

u Utility Knife

u Tape Measure

u Tooth Hand Saw

u Carpenter’s Square

u Pencil

u Chalk Line

u ANSI Z87 Eye Protection

u Small Tool For Clearing Jams

u Removeable Threadlock Glue

Racking the Flooring

 

(See Figures 20 and 21)

 

Refer to flooring manufacturer’s preparation procedures regarding moisture content and floor preparation before laying the flooring boards.

Figure 20 - “Pop” the tongue into the groove

First refer to flooring manufacturer’s preparation procedures regarding moisture content and floor preparation before laying the flooring boards.

To correctly install hardwood flooring, it must be properly racked before being nailed into place. After placing the first board, follow these instructions to rack the flooring:

1.Place flooring groove onto the tongue of previously installed board.

2.Use the rubber end of the mallet to “pop” the tongue into the groove (see Figure 20).

3.Use the metal end of the mallet to rack the board tightly against adjacent board. The metal end is tapered away from top of flooring to prevent unwanted damage to top surface (see Figure 21).

Firing the Nailer

Note: Make sure the rubber bumper on the flooring nailer is in the up position before adding the air hose, if not, the nailer may cycle (see Figure 15).

1.Connect the air supply to the nailer.

2.Load fasteners (see Loading/Unloading the Nailer section).

Do NOT fire the tool unless it is securely placed. If tool is notsecurely placed, there is a risk of flying fasteners that may cause death or serious

injury.

An improperly functioning tool must not be used. Do not actuate the tool unless the tool is placed firmly against the work piece.

3.Place the tool on the floor (see Figure 22) with the shoe plate resting on the racked floor board. Make sure the fastener ejection nozzle is firmly placed against the board tongue.

Figure 21 - Rack the board tightly against adjacent board

Figure 22 - Rest shoe plate on floor board

www.chpower.com 13