Check the memory card

- Cannot access the memory card. Check the memory card and make sure it is inserted cor- rectly.

- A memory card error occurred. The camcorder cannot record or display the image. Try removing and reinserting the memory card, or use a different memory card.

-You inserted a MultiMedia Card (MMC) into the camcorder. Use a recommended memory card (A23).

-If after the message disappears, 9appears in red, perform the following: Turn off the cam- corder and remove and reinsert the memory card. If 8turns back to green you can resume recording/playback. If the problem persists, save your recordings (A105) and initialize the memory card (A29).

Check whether the lens cover is open - Slide the lens cover switch down.

Do not disconnect the power source. Cannot write data with this connection. To write data to the camcorder, connect the compact power adapter then reconnect the camcorder and computer. Do not disconnect the USB cable unless you first use the computer to safely end the connection.

-The camcorder cannot be operated while it is not being powered by the compact power adapter and is connected to a computer with the supplied USB cable. In addition, scenes can- not be written back and music files cannot be transferred to the camcorder. To avoid corrupt- ing the data in the camcorder’s memory, use the computer’s Safely Remove Hardware function to end the connection and disconnect the USB cable before using the camcorder.

-To transfer files to the camcorder, use the computer’s Safely Remove Hardware function to end the connection, disconnect the USB cable, power the camcorder using the compact power adapter and only then connect it to the computer again.

Do not disconnect the power source. Do not disconnect the USB cable unless you first use the computer to safely end the connection.

-When the camcorder is in mode and is connected to the computer with the supplied USB cable, the camcorder cannot be operated. Disconnecting the USB cable or power source while this message appears may result in permanent loss of the recordings in the camcorder. Use the computer’s Safely Remove Hardware function to end the connection and disconnect the USB cable before using the camcorder.

File name error

-The file or folder number has reached its maximum value. Save your recordings (A105), set 1>q>[File Numbering] to [Reset] and initialize the memory (A29).

Initialize only using the camcorder

-There is a problem with the file system that prevents accessing the selected memory. Initialize the memory with this camcorder (A29).

LCD Screen has been dimmed Use the [LCD Backlight] setting to change the brightness - Change the 1>t>[LCD Backlight] setting to [Normal] or [Bright].

168 Š Additional Information