Canon DC220, DC50, DC230 List of Messages, Memory Card Operation, Printing, Message Explanation

102 Trouble?

Memory Card Operation

Problem		Solution
Memory card cannot be	Memory card was not facing the correct direction. Turn the		28
inserted.	memory card over and reinsert it.
Memory card cannot be	Memory card is full. Erase still images to free some space or		73
recorded.	replace the memory card.
	Memory card was not initialized. Initialize the memory card.		76
	The folder and file numbers have reached their maximum value.		50
	Set [FILE NOS.] to [RESET] and insert a new memory card.
Memory card cannot be played	Insert a memory card.		28
back.
	Set the camcorder to	.	41
	Make sure the memory card is selected as the media for still		37
	images.
Image cannot be erased.	Image is protected. Cancel the protection.		75
“ ” flashes in red.	Card error occurred. Turn off the camcorder. Remove and		76
	reinsert the memory card. Initialize the memory card if flashing
	persists.
Printing

Problem		Solution
The printer is not operating	Disconnect the USB cable and turn off the camcorder and the		–
even though the camcorder	printer. After a short while, turn them on again, set the
and printer are correctly	camcorder to	mode and restore the connection.
connected.

List of Messages

Message	Explanation
SET THE TIME ZONE,	You have not set the time zone, date and time. This message	32
DATE AND TIME	appears each time you turn the power on until you set the time
	zone, date and time.
CHANGE THE BATTERY	Battery pack is exhausted. Replace or charge the battery pack.	23
PACK
CANNOT ENTER THE	The camcorder cannot enter the Quick Start standby mode while	38
STANDBY MODE NOW	the disc is being recognized after first inserting it or if the remaining
	battery charge is too low.
UNABLE TO RECOGNIZE	The disc may not be recognized by this camcorder if it was	–
THE RECORDING MODE	initialized with a different device.
OF THE DISC
	You inserted a disc recorded in a different Television System (PAL	–
	or SECAM).