a: Fully Automatic Wireless Flash Shooting

5 Set the flash mode to <a>.Press the <E> button on the master unit and set the flash mode to <a>.

The slave unit is set automatically to <a> during shooting via the control from the master unit.

To also fire the master unit, set the master flash firing to ON (p.55).6 Check the transmission status and that the flash is ready.Check that the <D> lamp is lit in green.

When the slave flash is ready, the AF-assist beam emitter blinks at 1-second intervals.

Check that the <Q> slave flash-ready icon is lit on the master unit’s LCD panel.

When the recycling of all the flash units is completed, the master unit’s flash-ready lamp lights.

7 Check the operation.Press the master unit’s test flash button.

X The slave unit flashes. If the slave unit does not fire, check that it is placed within the operation range.

8 Take the picture.

Set the camera and take the picture, in the same way as with normal flash shooting.

XIf a standard flash exposure was obtained, the flash exposure confirmation lamp lights for 3 sec.

58