5Push the joystick () towards / to begin the playback.

DURING PLAYBACK

6Push the joystick ( ) towards

/ again to pause the playback.

7Push the joystick () towards to stop the playback.

TO ADJUST THE VOLUME

1 Press FUNC. .

2Select () [ SPEAKER VOLUME] and adjust () the volume.

•The sound from the built-in speaker will be muted when you close the LCD panel or while the STV-250N Stereo Video Cable is connected to the AV terminal.

•If you turn off the volume completely, the icon will change to .

3Press FUNC. to close the menu.

SPECIAL PLAYBACK MODES

To operate the special playback modes use the buttons on the wireless controller. There is no sound during the special playback modes. To return to normal playback, push the joystick () towards / or press PLAY on the wireless

controller.

Fast Playback: Push the joystick ()

towards or () towards . Hold the joystick pressed down to rewind/fast forward the tape while continuing the playback. You can also press and hold REW or FF on the wireless controller.

Reverse Playback: During normal

playback press .

Frame Reverse/Advance: During playback

pause press /. Keep pressed

for continuous frame-by-frame playback. Slow Playback: During normal or reverse

playback press SLOW .

Double Speed Playback: During normal or reverse playback press .

Playback 33

NOTES

You can display the date and time of the recording ( 55).

During some special playback modes, you may notice some video problems (blocky video artifacts, banding, etc.) in the playback picture.

To protect the tape and video heads, the camcorder will enter the stop mode ( ) if left in

playback pause () mode for 4 minutes 30 seconds. To resume the playback push the joystick ( ) towards /.

Returning to a Pre-marked Position

If you wish to return to a particular scene

 

later, mark the point with the zero set

 

memory and the tape will stop at that

 

 

point when you rewind/fast forward the

Basic

tape.

 

 

 

 

 

 

 

 

 

 

 

(

 

10)

Functions

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1 While recording or during playback,

 

 

press ZERO SET MEMORY on the

 

 

wireless controller at the point you

 

 

wish to return to later.

 

•The time code changes to “0:00:00 ”.

•Press ZERO SET MEMORY again to cancel the memory.

2If you marked the zero memory

while recording, set the camcorder

to mode. If you marked the zero memory during playback, press .

3 Press to locate the zero mark.

•If the tape counter shows a negative

number, press instead.

• appears and the camcorder rewinds/fast forwards the tape.

•The tape stops at or near the zero

mark, disappears and the correct time code will be displayed again.