Carrier 48HJ004---007, 48HE003---006 installation instructions Unit Operating Dimensions Weight

C06111

				Fig. 6 ---	Rigging Details
UNIT	OPERATING					DIMENSIONS
		WEIGHT		“A”			“B”			“C”
48HE
	lb		kg	in.	mm	in.		mm	in.		mm
003	530		240	73.69	1872	35.50		902	33.31		847
004	540		245	73.69	1872	35.50		902	33.31		847
005	560		254	73.69	1872	35.50		902	33.31		847
006	635		288	73.69	1872	35.50		902	33.31		847
UNIT	OPERATING					DIMENSIONS
		WEIGHT		“A”			“B”			“C”
48HJ
	lb		kg	in.	mm	in.		mm	in.		mm
004	530		240	73.69	1872	35.50		902	33.31		847
005	540		245	73.69	1872	35.50		902	33.31		847
006	560		254	73.69	1872	35.50		902	33.31		847
007	635		288	73.69	1872	35.50		902	33.31		847

48HE,HJ

C06208

Fig. 7 ---Roof Curb Alignment

Support gas piping as shown in the table in Fig. 11. For example, a 3/4-in. gas pipe must have one field-fabricated support beam every 8 ft. Therefore, an 18-ft long gas pipe would have a minimum of 3 support beams, and a 48-ft long pipe would have a minimum of 6 support beams.

!WARNING

PROPERTY DAMAGE HAZARD

Failure to follow this warning could result in personal injury, death and property damage.

All panels must be in place when rigging and lifting.

See Fig. 11 for typical pipe guide and locations of external manual gas shutoff valve.

NOTE: If accessory thru-the-bottom connections and roof curb are used, refer to the Thru-the-Bottom Accessory Installation Instructions for information on power wiring and gas connection piping. The power wiring, control wiring and gas piping can be routed through field-drilled holes in the basepan. The basepan is specially designed and dimpled for drilling the access connection holes.

!WARNING

FIRE, EXPLOSION HAZARD

Failure to follow this warning could result in personal injury, death and/or property damage.

When connecting the gas line to the unit gas valve, the installer MUST use a backup wrench to prevent damage to the valve.

5