non−programmable models, pressing the features button shall toggle the state of the dry contact.
In a heat pump application, when the mode is set to “em heat” the auxiliary heat will turn on for 3 minutes. The clock display will count down from 180 to 0 during this test.
TO TEST FAN
Fan button switches FAN icon between AUTO and On. While On is displayed, G output will be energized, turning fan on. On some fan coils, fan continues to operate for 90 sec after G signal is removed.
Final Settings
Be sure to press DONE to exit installer setup mode. If the system is to be left in operation after installation is complete, use MODE button to select between HEAT, COOL, or AUTO to provide desired operation of heating, cooling, or auto.
On the programmable models, the default setpoints and programmed schedule conform to the Energy Starr requirements of the U.S. Department of Energy for both heating and cooling. These provide energy saving temperature settings. Refer to Table 1.
Table 1 – Energy Star Default Schedule
SCHEDULE | HEAT | COOL |
|
|
|
Wake 6:00 AM | 68_F/20_C | 78_F/26_C |
|
|
|
Day 8:00 AM | 60_F/16_C | 85_F/29_C |
|
|
|
Evening 5:00 PM | 68_F/20_C | 78_F/26_C |
|
|
|
Sleep 10:00 PM | 60_F/16_C | 82_F/28_C |
|
|
|
46
