Introduction
DIP Switches
DIP Switch Setting | Description | |
| 1=off | Normal Operation. |
| ||
| ||
| 2=off |
|
|
|
|
|
|
|
| 1=off | DHCP Server function disabled. |
| ||
| ||
| 2=on |
|
|
|
|
|
|
|
| 1=on | Used to restore Default IP Address |
| ||
| ||
| 2=off | and clear Password (See below). |
|
|
|
|
|
|
| 1=on | Normal Operation. |
| ||
| ||
| 2=on |
|
|
|
|
|
|
|
Restore Default IP Address and Clear Password
If the Wireless Gateway's IP Address or password is lost, the following procedure can be used to recover from this situation.
1.Turn the power to the Wireless Gateway OFF.
2.Set DIP switch 1 ON.
3.Turn the power to the Wireless Gateway ON.
4.Operate DIP switch 1 in the following sequence (you have 15 seconds to complete the sequence):
•OFF
•ON
•OFF
5.The Wireless Gateway will now reset, and the Red Status LED flash. The following changes will have been made. (Other configuration data is unchanged.)
•IP Address set to its default value of 192.168.0.1
•Network Mask set to 255.255.255.0
•DHCP Server is enabled, and will allocate IP Addresses in the range 192.168.0.2 to 192.168.0.51.
•The password cleared (no password).
6.You can now connect to the Wireless Gateway and make any configuration changes required.
7
