Milan Technology MIL-W1311 manual Other Unix Systems, Wireless Station Configuration, LPD Printing

PC Configuration

Other Unix Systems

For Internet Access via the Wireless Gateway

•Ensure the "Gateway" field for your network card is set to the IP Address of the Wireless Gateway.

•Ensure your DNS settings are correct.

LPD Printing

To use LPD printing to the Wireless Gateway's printer, install an LPD printer using the stan- dard procedure for your system.

•Use the Wireless Gateway's IP Address as the location of the remote host

•Use L1, L2, or L3 for the name of the printer on the remote host.

On the Wireless Gateway, the logical printers (L1, L2, and L3) can be configured on the Options - Printer Port screen.

Wireless Station Configuration

This section applies to all Wireless stations wishing to use the Wireless Gateway's Access Point, regardless of the operating system which is used on the client.

To use the Wireless Access Point in the Wireless Gateway, each Wireless Station must have compatible settings, as follows:

Mode	The mode must be set to Infrastructure.
SSID (ESSID)	This must match the value used on the Wireless Gateway. The default
	value is default
	Note! The SSID is case sensitive.
WEP	By default, WEP on the Wireless Gateway is disabled.
	• If WEP remains disabled on the Wireless Gateway, all stations must
	have WEP disabled.
	• If WEP is enabled on the Wireless Gateway, each station must use
	the same settings as the Wireless Gateway.

39