Milan Technology MIL-W1311, MIL-W0311 manual Rear Panel, Introduction

	Introduction
Wireless	On - Wireless connection available; Wireless Access Point is ready for
	use.
	Off - No Wireless connection available.
	Flashing - Data is transmitted or received via the Wireless access point.
	This includes "network traffic" as well as user data.
Print Error	On - Printer error detected.
	Off - No printer error detected.
Print Act	On - Connection to printer established.
	Off - No connection to printer; printer is Off or Off-line.
	Flashing - Data is being transmitted to the printer.
COM	Off - Idle or no active device connected to the serial (RS232) port.
(Serial Port)	Flashing - Data is transmitted or received via the serial (RS232) port.

Rear Panel

	Figure 2: Rear Panel
Serial Port	RS232 Serial Port. If you have an analog modem or ISDN TA,
	connect it here.
Printer Port	Standard parallel printer port. If you wish to share a printer, connect it
	here.
WAN port	Connect the DSL or Cable Modem here. If your modem came with a
(10BaseT)	cable, use the supplied cable. Otherwise, use a standard LAN cable.
DIP switches	Refer to the following table.
PC port	If connecting directly to your PC (no Hub) use this port and a stan-
(10/100BaseT)	dard LAN cable (RJ45 connectors).
	Use EITHER the PC port OR the Hub port, NOT both.
HUB port	Use a standard LAN cable (RJ45 connectors) to connect this port to a
(10/100BaseT)	10BaseT or 100BaseT hub.
	Use EITHER the PC port OR the Hub port, NOT both.

5