Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI 3-11
Network Connections
Preconfigured Connections
NOTE: For a manually specified network mode (Internet Protocol: Use the following IP address), the
default route does not get installed until both the Default Route checkbox is enabled AND the user has
entered a valid non-0.0.0.0 Gateway IP in the Default Gateway field.
IP Address Distribution (This name is a link to the IP Address Distribution (DHCP) window.)
Disabled Disables address distribution. Default.
DHCP Server Configures DHCP Server.
Start IP Address - Starting address of the client address pool
End IP Address - Ending address of the client address pool
Subnet Mask - Subnet mask of the Start/End IP address listed above.
WINS Server IP Address - Windows Internet Name Service Server IP
address.
Lease Time In Minutes - Lease during that the DHCP server applies to the
client assignment.s
Provide Host Name if Not Specified by Client - Check to enable.
DHCP Relay New IP Address - Opens a new window. Enter the address of the DHCP
Relay Server.
Routing (This name is a link to the Advanced/Routing window.)
Routing Mode Display/edit the routing mode.
Route - Routing is used if public is visible on both sides.
NAPT - Default. NAPT is used if doing private IPs on the Ethernet side or if
you want to hide specific publics on the internal side.
SIP ALG Note: This field only applies when the Routing Mode is set to NAPT.
This field allows the customer to turn off the SIP ALG on external
interfaces.
Checked - the SIP ALG will be switched off.
Unchecked - the SIP ALG will not work.
Device Metric Value of Metric of IP network on this interface in the Routing Table. Range
is 0-255.
Default Route Check to enable default route.
Proxy ARP - Ethernet
ARP Proxy
Check to enable Proxy ARP.
Routing Protocol None - Disable the routing protocol on this interface.
OSPF - Set the routing protocol to OSPF on this interface. There is a link
below the option to configure OSPF.
RIP - Set the routing protocol to RIP on this interface.
Listen to RIP Messages - None, RIPv1, RIPv2, RIPv1/2
Send RIP Messages - None, RIPv1, RIPv2 - Broadcast, RIPv2 - Multicast

Internet Connection

Firewall
Note: This name is a link to the Security window
Enables/Disables Firewall for this device.
Additional IP Addresses Opens a window to add an additional IP address with subnet mask.
Field Definition (Continued)