Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI 3-23
Network Connections
Connections that Require Configuration
The following are field definitions for the Configure Serial 1 window:
Field Definition
General
Device Name Displays the device name.
Status Displays the current status.
Schedule Availability Defines when the WAN is available. The default is Always. To create
a Schedule Availability rule, click New.
Network Defines the type of network:
WAN - Wide Area Network (Default).
LAN - Local Area Network
DMZ - Demilitarized Zone
Connection Type Displays the connection type:
Adit 3000: PPPoT1
Adit MSR: Serial
MTU Maximum Transmission Unit. Sets the largest packet size (bytes) the
network will transmit.
Automatic at 1500
Manual at a range of 576 to 1500.
Underlying Device Displays the device/connection required for this interface:
Adit 3000: Displays the T1 in this connection. This is a link to the
High Speed Serial Configuration window. See Underlying Device -
High Speed Serial Configuration (Adit 3000 Only) on page 3-25.
Adit MSR: Displays the LCC in this connection.
PPP - Note: These fields do not display when The Internet Protocol field is set to "unnumbered"
On Demand Attempts to connect only when packets are sent.
Time Between
Reconnect Attempt
Sets the interval of time between reconnect attempts.
Range is 0 - 99999 seconds. Default is 30 seconds.
Restart Timer Range is 1 - 65535 seconds. Default is 3 seconds.
PPP Authentication
Login User Name Enter Login User Name, with a maximum of 100 characters.
Login Password Enter login password.
Select to enable support of the following:
Support Unencrypted Password (PAP)
Support Challenge Handshake Authentication (CHAP)
Support Microsoft CHAP (MS-CHAP)
Support Microsoft CHAP Version 2 (MS-CHAPv2)
PPP Encryption The following PPP encryption can be enabled by checking the boxes:
Require Encryption (Disconnect if server declines)
Support Encryption (40 bit keys)
Support Maximum Strength Encryption (128 bit keys)
Internet Protocol
Unnumbered Treat this as an un-numbered interface per RFC 1812. Default.
Obtain an IP Address
Automatically
Sets the WAN to use DHCP to obtain an IP address.
Override Subnet Mask - Set mask, override any previous setting.
Use the Following IP
Address
IP Address - Sets the IP Address
Override Subnet Mask - Set mask, override any previous setting.