Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI 3-19
Network Connections
Connections that Require Configuration
The following are field definitions for the Configure Multilink 1 window:
Field Definition
General
Device Name Displays the device name.
Status Displays the current status.
Schedule Availability Defines when the WAN is available. The default is Always. To create a
Schedule Availability rule, click New.
Network Defines the network type:
WAN - Wide Area Network (Default).
LAN - Local Area Network
DMZ - Demilitarized Zone
Connection Type Displays the connection type (Multilink).
MTU Maximum Transmission Unit. Sets the largest packet size (bytes) the network
will transmit:
Automatic at 1500
Manual at a range of 576 to 1500.
Underlying Device Displays the device(s)/connection(s) required for this interface:
Adit 3000: Lists the T1(s) in this connection. These are links to the High
Speed Serial Configuration window. See Underlying Device - High Speed
Serial Configuration (Adit 3000 Only) on page 3-25.
Adit MSR: Lists the LCC(s) in this connection.
PPP
QOS Interleaving Enables Interleaving. The QoS Interleaving is used when there are QoS
considerations with voice or data. Packets are split with a low ToS precedence.
Link Fragmentation Sets the threshold byte size of the packet for Interleaving.
Range is 320 - 1600, with a default of 1600. If the packet is > the set threshold,
the packet will be split in half and sent.
PPP Authentication
Login User Name Enter Login User Name, with a maximum of 100 characters.
Login Password Enter login password.
Select to enable support of the following:
Support Unencrypted Password (PAP)
Support Challenge Handshake Authentication (CHAP)
Support Microsoft CHAP (MS-CHAP)
Support Microsoft CHAP Version 2 (MS-CHAPv2)
PPP Encryption The following PPP encryption can be enabled by checking the boxes:
Require Encryption (Disconnect if server declines)
Support Encryption (40 bit keys)
Support Maximum Strength Encryption (128 bit keys)