3-20 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Network Connections
Connections that Require Configuration
NOTE: The Adit uses the compressed format of protocol encapsulation, which means it uses
a 1-byte protocol instead of 2 bytes. The unit automatically detects when the opposite end
does not support this, by protocol rejects, and reverts to uncompressed to accommodate older
devices that may not support Rx on the 1-byte format.
Internet Protocol
Unnumbered Treat this as an un-numbered interface, as per RFC 1812.
Obtain an IP Address
Automatically
Sets the WAN to use DHCP to obtain an IP address.
Override Subnet Mask - Set mask, override any previous setting.
Use the Following IP
Address
IP Address - Sets the IP Address
Override Subnet Mask - Set mask, override any previous setting.
DNS Static Entries (This name is a link to the Advanced/DNS Static Entries window.)
Obtain DNS Server
Address Automatically
Sets the interface to obtain a DNS Server address.
Use the Following DNS
Server Address
Sets the DNS Server Address.
Primary DNS Server - Enter the specific DNS server address to use.
Secondary DNS Server - Enter a secondary DNS server address to use.
Routing
Routing Mode Displays the current routing mode.
Route - Routing is used if public is visible on both sides.
NAPT - NAPT is used if doing private IPs on the Ethernet side or if you want
to hide specific publics on the internal side.
SIP ALG This field allows the customer to turn off the SIP ALG on external interfaces.
Checked - the SIP ALG will be switched off.
Unchecked - the SIP ALG will not work.
Device Metric Value of Metric of IP network on this interface in the Routing Table. Range is
0-255, with a default of 20.
Default Route Check to enable default route. Default is enabled.
Routing Protocol None - Disable the routing protocol on this interface.
OSPF - Set the routing protocol to OSPF on this interface. There is a link
below the option to configure OSPF.
RIP - Set the routing protocol to RIP on this interface.
Listen to RIP Messages - None, RIPv1, RIPv2, RIPv1/2
Send RIP Messages - None, RIPv1, RIPv2 - Broadcast, RIPv2 - Multicast
Internet Connection
Firewall
Note: This name is a link to the Security window
Enables/disables Firewall for this device.
Additional IP Addresses Opens a window to add an additional IP address with subnet mask.
Field Definition (Continued)