Marrakesh™
INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed in instructions.
Before discarding packaging material, be certain that all parts have been removed.
GETTING STARTED
Carton Contents
The fan carton contains the fan body, warranty card, owner’s manual, and all the parts necessary to assemble and install your Casablanca ceiling fan. These parts are shown at the start of each installation section. Before you start, go through this Owner’s Manual and confirm that you have all the parts shown in each section.
Be sure to use only genuine Casablanca blades. The blade shrink wrap holds 3 blades of matched weight. If more than one fan is being installed, be sure not to mix blade sets.
CAUTION: When removing the shrink wrap, be careful not to scratch the blades.
CEILING HARDWARE
CROSSBAR MOUNT- | WIRE NUT (4) |
ING BRACKET |
|
additional hardware
21/4” x
1” x | FLAT WASHER (2) | |
head screw (2) | ||
|
SUPPORT INSTALLATION PARTS
LAG SCREW | LARGE |
3/8” #7 X 5” (1) | FLAT WASHER |
| 3/8” (1) |
CANOPY HARDWARE
CANOPY
HATCH
CANOPY
CANOPY SCREW
CANOPY LOCK WASHER
#8 (4)
getting started - continued
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked acceptable for ceiling fan support.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker or fuse box), lower the old fixture and disconnect the wiring. Check the ceiling fixture outlet box to be sure that it is a UL listed ceiling box for ceiling fan applications. If it is not, a new box must be installed.
3
