blade assembly on fan installation
Step 12. Rotate blade assembly until the other blade iron hole aligns with the
Perma•lock™ Hardware
ALLEN SET SCREW | 3mm |
|
|
| 6” downrod | ||
allen wrench | MOTOR COVER | & Ball assembly |
Fan preparation
importtanttsafetytyinformattion!
beforebeforestartingstartingthetheinstallationinstallationofofyourourceililing gfan,fan,installthethethreaded downrodintothethemotorotorcoupling gandandlocklockthetheassemblmblyy
Prepare for fan installation as follows:
Step 13. Place the motor cover on the downrod as shown.
Step 14. Route the wires from the motor through the Perma•Lock™ downrod and ball assembly.
Motor Cover
motor wires
downrod
Tip: The downrod has a tapered thread that is designed to lock completely when correctly installed.
Step 15. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning, this will take at least four and a half full turns.
Step 16. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the down- rod before securely tightening the allen set screw may cause the fan to separate from the downrod during normal operation!
tapered thread
ALLEN
SET SCREW
motor
coupling
& Ball
assembly
8