ADIC Scalar 1000, SNC 5100 manual Quick Component Check, Perform Health Check

SNC 5100

Step 3. Issue the sysVpdShow command.

For more information, see the "sysVpdShow or sysVpdShowAll" command on page 175.

Step 4. Report this information to your service representative, if you are asked for it.

Quick Component Check

Use this procedure to check system components:

Step 1. Connect a service terminal to the SNC 5100.

For information about how to do this, see “Connecting to the

Service Port” on page 95.

Step 2. Press the Enter key on the service terminal.

If the prompt is not displayed, go to “Service Port MAP” on page 75.

Step 3. From the service terminal, enter the showBox command.

For more information, see the "showBox" command on page 170.

Step 4. If an installed component does not show up in the display, go to the correct MAP.

For example, if a SCSI interface is missing, go to “"SCSI Channel

MAP"” on page 50.

If a Fibre Channel is missing, go to “"Fibre Channel MAP"” on page 61.

Step 5. If all components display properly, proceed to "Perform Health Check".

Perform Health Check

Step 1. Stop all I/O.

Step 2. Remove the Ethernet cable if installed.

46 Start MAP

6-00020-02